Fixed Gas Detection

Accessories

In order to provide full system installation and operational capability, Status Scientific Controls offer a range of accessories for use with it's range of fixed gas detector heads, a selection of which is shown below.

Flow Through Sampling Adaptor

FGD5/6-IR Adaptor

A flow through sampling adaptor is available for applications where gas samples are being drawn through sample tubes. The plug-in sampling adaptor is permanently connected to the fixed gas detector head. The standard fitting is a push fit connector for 6mm O.D tubing. Other fittings are available upon request.

Duct Air Sampling Units

Duct air sampling units are available for the company's various different gas detector heads. These allow the constant monitoring of duct air flow to be carried out without having to significantly modify the ducting itself

Collector Cone

Collector cones are normally used to give enhanced detection of gases such as methane which is lighter than air (relative density 0.55). The collector cone is attached to the bottom of a gas detector head and allows gas to be concentrated towards the gas sensor and is typically used where the sensor is sited over a particular process or where a leak is likely to occur.

Mounting Brackets

Gas detector head mounting brackets are available to suit individual applications.

Weather Guards

Weather Guard

A weather guard can be fitted over a fixed gas sensing head to protect it from ingress of water or contaminants; a typical use is in outdoor applications such as on oil platforms where the sensors are subjected to driving rain and salt spray. The weather guard has an integral sampling adaptor which enables the head to be tested and calibrated in situ.

Regulators and Calibration Sampling Adaptors

These are used in conjunction with test gases for calibration and routine testing of the gas detectors - refer to the Testing and Calibration Section for further details.

Order Codes

Stock No. Description
SS429 FGD3 Collector Cone
SS374 Swivel Mounting Bracket
SS375 Ceiling Mounting Bracket
SS396 Steel Junction Box
SS469 Duct Air Sampling Unit
SS475 FGD3 Weather guard
SS665 FGD5/6-IR Duct Mounting Kit
SS746 FGD10 Series Flow-Through Sampling Adaptor
SS747 FGD10 Series Calibration Adaptor c/w 1 Metre Tubing
SS749 FGD10 Series Weather guard
SS841 FGD9 Series Weather guard

Looking for the very best deals in Fixed Gas Detection?
sales@status-scientific.com • International - +44 (0) 1623 651381