Fixed Gas Detection Accessories MANUFACTURED BY STATUS SCIENTIFIC CONTROLS In order to provide full system installation and operational capability, Status Scientific Controls offer a range of accessories for use with it's range of fixed gas detector heads, a selection of which is shown below. 

Flow Through Sampling Adaptor 
 
A flow through sampling adaptor is available for applications where gas samples are being drawn through sample tubes. The plug-in sampling adaptor is permanently connected to the fixed gas detector head. The standard fitting is a push fit connector for 6mm O.D tubing. Other fittings are available upon request. 
Duct Air Sampling Units 
 
Duct air sampling units are available for the company's various different gas detector heads. These allow the constant monitoring of duct air flow to be carried out without having to significantly modify the ducting itself. 
 
Collector Cone 
 
Collector cones are normally used to give enhanced detection of gases such as methane which is lighter than air (relative density 0.55). The collector cone is attached to the bottom of a gas detector head and allows gas to be concentrated towards the gas sensor and is typically used where the sensor is sited over a particular process or where a leak is likely to occur. 
 
Mounting Brackets 
 
Gas detector head mounting brackets are available to suit individual applications. 
Weatherguards 
 
A weatherguard can be fitted over a fixed gas sensing head to protect it from ingress of water or contaminants; a typical use is in outdoor applications such as on oil platforms where the sensors are subjected to driving rain and salt spray. The weather guard has an integral sampling adaptor which enables the head to be tested and calibrated in situ. 
Regulators And Calibration Sampling Adaptors 
 
These are used in conjunction with test gases for calibration and routine testing of the gas detectors - refer to the Testing and Calibration Section for further details. 
Stock No. 
Description 
SS429 
FGD3 Collector Cone 
SS374 
Swivel Mounting Bracket 
SS375 
Ceiling Mounting Bracket 
SS396 
Steel Junction Box 
SS469 
Duct Air Sampling Unit 
SS475 
FGD3 Weatherguard 
SS665 
FGD5/6-IR Duct Mounting Kit 
SS746 
FGD10 Series Flow-Through Sampling Adaptor 
SS747 
FGD10 Series Calibration Adaptor c/w 1 Metre Tubing 
SS749 
FGD10 Series Weatherguard 
SS841 
FGD9 Series Weatherguard 
For Quality Gas Detection at 
 
Competitive Prices 
Contact 
 
sales@status-scientific.com 
International - +44 (0) 1623 651381 
For Quality Gas Detection at Competitive Prices 
 
Contact 
 
sales@status-scientific.com 
 
International - +44 (0) 1623 651381